GARDTEC 800 SERIES FAULTS
Each expander board being programmable for 4 x four wire zones, 8 x two wire zones or 8x two wire EOL zones. Part Set 2 may consist of a suite of zones that have been programmed as Part2 by the engineer. This will be displayed as Keypad x Tamper and will require a valid User Code entry to stop the sounders. It is a global setting. Five options are available that are selected with jumper links. Viewing The Event Log
One timer is available on the , and three on the control panel. Bell Delay used to be a Police requirement, but is now not often used in the UK. Table of Contents Add to my manuals Add. Program Confirm Sounder Mode? User number 1 will always be a Master Level User but the remaining User Codes may be programmed by a Master Code to the required level of access. With the display showing for example: This is a useful feature when part of the family may already be asleep when the system is being Part Set.
If the number of devices found does not correspond to the number fitted, check the wiring and re-map.
GARDTEC 800 User Instructions
When using the zone expander cable the following colours should be used see Figs 30a, 30b. After the installation has been completed refit the lid and secure with the retaining screw s. Display will differ dependant on panel version 3 xx-xx Whilst this display is showing the first five seconds press the keys shown in a, b or c for the reset required.
Typical use for this terminal would be the latch signal for PIRs and Shockgards 1 etc. No, create an account now. Reserved User Code User No. Otherwise 46 Press No. The has seven areas available.
All Ace Fobs or Prox are High Security The ident jumper should be positioned across the pins in one of the positions before the system is powered up. A1 indicates Area 1. This configuration gives the highest possible zone wiring security and a maximum of ten detectors may be wired on to each zone when this option is selected.
Remove- The zone may not be Removed Omitted by the end user.
The difference lies in the ability to have individual control of the Areas that been allocated to the code. The maximum current draw from the unit for all output combinations must not exceed the rated output. Show Status Enter a valid Code to display the Status for a further ten seconds. If set to Off, the bells will activate only when both Entry Time 1 and 2 have expired. Auto Only ACE units will be auto recognised when programming them onto the system. 800
DD requirements will still apply 5 Select 2: To change the fuse push the two halves of the holder together and twist anti-clockwise. With system part set 0 Cleaner code will set the remainder of the system.
gardtec series Questions & Answers (with Pictures) – Fixya
US Not present on keypads from This jumper is the user select. Mount the base to the wall using 30mm No. A Zone on Test will never trigger an alarm or send a central station signal. Enter a Master Code, the garctec may show: If Line Fault is not used the factory fitted link to 12V should be left in place.
RISCO GardTec ENG |
The Display will show: The zone descriptor is displayed whilst viewing the cause of an alarm, viewing the log, if a zone is violated during exit and when programming zone descriptors User Names Each user with the exception of the engineer may be allocated a user name of up to nine characters. These additional markings are disregarded within this manual.

Your installation company will give you further information on the scenarios when Group Area Codes may be used on your system. This may show for several minutes. This is to prevent other users straying into protected areas without warning. Share This Page Tweet.

If any area that is assigned to the zone is in entry then the zone faaults also in entry zone type will still apply. The zone allocation for the different modes is given below. Consideration also needs to be given as to the positioning of the remote keypads. If this option is programmed to 0 the Bell will not activate.
