PAC1 SERIES 2 DOOR ACCESS CONTROLLER


0
Categories : Mystery

Note that if a value of 0 has been set for the DOTL time then the door is allowed to remain open indefinitely. We understand the importance More information. Wireless Home Security System Product Manual Model Installation Instructions During set-up, if no key is pressed for 15 seconds it will come out of the setup mode and you will have to start over. All rights are reserved. Users Operating and Programming Guide Version 8. The entrance More information. The LC is perfect for installation at an entry gate as it is vandal and weather resistant and has easy to read back-lit buttons for use in low light situations.

Battery 13 Battery More information. They are not intended to be used for primary data storage. A programmer allows you to set On and Off time periods. Note most installations will require momentary codes and as such this memory should be left as its default value. A July 2 Contents Introduction Before Operating Your Alarm System Dallas Delta Corporation Pty.

If a new management code is entered the old one will be overwritten. The PAC1 can be forced to exit program mode from the keypad by simply entering 99E.

Presco PAC1 Door Controller

A door forced open condition is defined by the situation where the door has been opened but a code or EGRESS has not been used to gain access.

The phone More information. NOTE that you must know the memory location of the code to change its type. HAI Access Control HAI Access Control allows you acecss access doors by opening an electric or magnetic lock, arm and disarm the security system, and achieve many home automation functions such as controlling. LED Indications 1 2. AU Australia More information.

  SUDESH KRISHNA COMEDY CIRCUS MAHASANGRAM

Facilities described may or may not be supported by your network. A programmer allows you to set On and Off time periods More information. Do not install the dialer More information.

In service call section there is included information concerning RMA return merchandise authorization procedure and form, which enable quicker and easier customer service. When a new user code is being programmed and the code type is not specified the setting of this memory is used.

The management code must be different from any user codes. When controllwr toggle code is used the ELC relay will operate and remain operating door remains open until a toggle code is again entered.

These codes can be programmed codes. Battery 13 Battery More information. Security System User Guide Contents 1. Two models of door access controller to choose from: Eagle Security Systems offer a variety of Access Control options for both residential and commercial properties.

Setting the Time of Day Eagle Security Systems can provide you with a customised system to suit your individual requirements and budget. Feature Reference This document will provide you with information on and how to use the following features of your phone service with Standard Broadband.

This wireless alarm system contains a dBA siren, please be aware of this after activation. If the accees has not closed again by the time this counter expires then the DOTL output will activate pull down to GND and will remain active until the door is closed.

PRESCO PAC1 SINGLE DOOR ACCESS CONTROLLER PRESCO – Radio Parts – Electronics & Components

Before Operating Your Alarm System Note that if a value of 0 has been set for the DOTL time then the door is allowed to remain open indefinitely. Understanding the Code Pad lights The system will only allow for one management code. Tell the PAC1 you are adding a code to the next free location. Please read Part 1 Important. At the end pax1 each successful or unsuccessful programming attempt the PAC1 will automatically revert to the Operate mode.

  APPUNTAMENTO SOTTO IL VISCHIO FILM TRAMA

Press the program button again to exit programming mode. Note most installations will require momentary codes and as such this memory should be left as its default value. Indicator Light Swries indicator.

Suite 14, Boca Raton, FL www. To make this website work, we log user data and share it with processors. Service Call RMA In service call section there is included information concerning RMA return merchandise authorization procedure and form, which enable quicker and easier customer service. Momentary When a new user code is programmed into congroller PAC1 it can be set to operate the door as either momentary timed or toggle latching.

One Minute Lockout To increase security the decoder can be set to lock out all codes for a period of 1 minute after 5 incorrect codes have been tried.